Analysis · 3 min read
Electrolyzer efficiency: comparing stack and system electricity use
Compare measurement boundaries and operating conditions before comparing electrolyzer electricity figures.
Start with the measurement boundary
Two electrolyzer offers can quote different electricity consumption even when their equipment performs similarly. Ask where electricity is measured and which hydrogen output is counted. Specific electricity consumption relates electricity input to hydrogen produced, usually in kilowatt-hours per kilogram. Comparison requires matching both boundaries.
The US Department of Energy (DOE) separates stack and system performance for proton exchange membrane (PEM) electrolysis. Its 2022 status column reports 51 kWh/kg of hydrogen for the stack and 55 kWh/kg for the system. These are DOE status figures for that technology and year, not measurements of a particular supplier or a universal plant allowance.
Ask suppliers for a diagram showing the meter and equipment included. One offer may include cooling or gas treatment while another excludes it. Such figures answer different questions. Request a common boundary, then list any equipment outside it separately.
Sources
- [1] US Department of Energy: Technical Targets for Proton Exchange Membrane Electrolysis
As of: 29 May 2026
Last confirmed: 16 Nov 2026
Match the product and energy inputs
The denominator matters too. Ask whether kilograms refer to hydrogen leaving the stack or usable product at the plant boundary, and whether treatment losses are counted. Record purity, delivery pressure, load, water supply and ambient conditions. A figure at one set of conditions is not a guarantee at another.
If the specified product pressure needs downstream compression, include its electricity in the comparison or show it separately. Its requirement depends on the design and delivery specification. A generic product page cannot establish a universal compression or purification penalty.
DOE 2022 high-temperature electrolysis status lists 38 kWh/kg for system electrical efficiency and 47 kWh/kg for system energy efficiency, including thermal input. DOE says that status reflects typical performance and durability of industry stacks and systems tested at Idaho National Laboratory from 2020 through 2022. This high-temperature difference is not an OEM loss breakdown and is not a figure to apply to PEM equipment.
Sources
- [2] US Department of Energy: Technical Targets for High Temperature Electrolysis
As of: 29 May 2026
Last confirmed: 16 Nov 2026
Make aging and cost assumptions visible
An efficiency percentage needs its heating-value basis as well as its boundary. Higher and lower heating values use different definitions of hydrogen energy, so percentages on these bases should not be compared directly. Ask suppliers to identify the basis and show the underlying energy consumption.
A single initial test does not describe performance throughout a contract. DOE presents PEM degradation and lifetime separately from initial efficiency. It defines end of life as a 10% voltage loss from beginning-of-life operation after any break-in or conditioning period, measured at the same current density. DOE says that evaluating degradation against its targets must include operation near the stack's nominal operating point and also consider dynamic operation and on-off cycling where the application requires them. The 2022 status value is based on continuous operation. The 2026 figures are targets, not guarantees for a particular unit.
For a purchase, agree on an initial test, operating profile and method for assessing later performance. Specify how electricity and hydrogen are measured and how start-up, standby and off-specification product are treated. Contract terms depend on negotiations.
Use the agreed energy boundary in the hydrogen cost model alongside electricity prices and the operating profile. Capital cost, utilization and maintenance also affect the comparison. Keep adjustments visible, and obtain a configuration-specific estimate where a supplier has not supported one.
Sources
- [1] US Department of Energy: Technical Targets for Proton Exchange Membrane Electrolysis
As of: 29 May 2026
Last confirmed: 16 Nov 2026
Related analyses
Explore related records
Research method
Research and writing were AI-assisted and reviewed before publication.